WHAT IT DOES
Drills are primarily used for making round holes and screwing fasteners.
This corded drill is for screwdriving and impact drilling into wood, metal, and masonry. The strength of this drill may however not suit all masonry, if you're having to apply a lot of pressure then it may not be an appropriate strength/bit and you could end up damaging the drill by doing so.
ABOUT THIS TOOL
- Comes with a UK mains plug
- Power cable is 2.4m long
- In-built chuck sleeve
- Comes with chuck adaptor and chuck key
- Depth gauge
- Comes with SDS drill bits 8/10/12 X 150mm
- Takes 13mm diameter bits
SAFETY & PPE
Ear protection - RECOMMENDED
Eye protection - RECOMMENDED
PPE available at the library for a suggested donation
YOU MAY ALSO NEED
Specific drill bits for the screw head type and/or material you are using the drill for.
If drilling into a wall to fix something to it you may also need wall plugs and screws
Extension cable
HOW TO USE IT
The power can be altered using a little blue dial located on the trigger. Pull the trigger to power the drill, to continually power the drill there is a blue button near the trigger you can use.
There is a blue dial on left side that turns to change between impact and hammer drilling.
There is a blue button that pushes from one side to the other to change direction of drilling.
Pull back in-built chuck sleeve to change included SDS drill bits.
There is a chuck key for loosening or fastening the drill head.