Angle Grinder - 230mm - 2000W Check Availability

*PLEASE NOTE THIS IS A LARGE & POWERFUL ANGLE GRINDER*

WHAT IT DOES

Angle grinders use a spinning disk that can cut a variety of materials (wood, masonry, tile & metal), remove paint, grind and polish.

ABOUT THIS TOOL

• Large angle grinder
• E-manual attached to this page
• Corded and connects to standard mains electricity
• Cable reaches 2.5m
• 6600rpm
• Suitable for all standard disks up to 230mm, bore 22.23mm
• Thread of spindle M14

SAFETY & PPE

Mask (full face visor if working with metal)- ESSENTIAL

Glasses - ESSENTIAL

Ear protection - ESSENTIAL

Gloves & skin covered (if working with metal) - ESSENTIAL

PPE available at the library for a suggested donation

YOU MAY ALSO NEED

Clamps to hold the material

Extension lead if the cable is too short

HOW TO USE IT

Having attached your appropriate disk and handle to the grinder, set the correct speed for what you intend to do (details in manual attached). Push trigger forward and up to turn the angle grinder on, you have to keep your finger on the trigger to keep the power with your other hand on the handle. You will hold the grinder to the material with medium pressure at a specific angle, which angle will depend on the job you are doing. Once you have finished lift your finger from the trigger and allow the disk to fully stop before putting it down.

Keep fingers and cord away from the disk.

Take caution when cutting metal as sparks will fly.

Instructional video for a similar jigsaw: